page_banner

products

Best MicroNet™ Plus Digital Control Suppliers - Woodward 9907-028 SPM-A speed and phase matching synchronizer – RuiMingSheng

short description:


Product Detail

Product Tags

Related Video

Feedback (2)

To be a result of ours specialty and service consciousness, our company has won a superb reputation between customers all around the environment for Abb Ci801-Ea 3bse022366r2 , Abb 07kt97 Gjr5253000r0270 , triple-module redundancy (TMR) architecture , We warmly welcome customers from all over the world for any kind of cooperation with us to build a mutual benefit future. We are devoting ourselves wholeheartedly to offer customers the best service.
Best MicroNet™ Plus Digital Control Suppliers - Woodward 9907-028 SPM-A speed and phase matching synchronizer – RuiMingSheng Detail:

Description

Manufacture Woodward
Model 9907-028
Ordering information 9907-028
Catalog SPM-A speed and phase matching synchronizer
Description Woodward 9907-028 SPM-A speed and phase matching synchronizer
Origin United States (US)
HS Code 85389091
Dimension 16cm*16cm*12cm
Weight 0.8kg

Details

Description

The SPM-A Synchronizer biases the speed of an off-line generator set so that the frequency and phase match those of another generator or the utility bus. Then it automatically issues a contact closure signal to close the circuit breaker between the two when frequency and phase are matched within limits for a specified match-up time. The SPM-A is a phase-locked-loop synchronizer and strives for a perfect match of frequency and phase.

The SPM-A Synchronizer with voltage matching generates additional raise and lower signals (relay contact closures) to the generator’s voltage regulator. Voltages must match within the SPM-A’s tolerance before breaker closure occurs. For single-unit synchronization, installation of one synchronizer on each generator allows each unit to be individually paralleled to the bus. For multipleunit synchronization, one synchronizer can synchronize up to seven paralleled generator units simultaneously to another bus. Both synchronizers versions have three output options: high impedance, low impedance, and EPG.

Select the high impedance output for single-unit synchronization when the engine is controlled by a Woodward 2301 control. Select the low impedance output for single-unit synchronization when the engine is controlled by a Woodward 2301A, 2500, or Electrically Powered Governor (EPG) control through a Generator Load Sensor. Use the EPG output when using a Woodward EPG control without load sensing. Both units have the following features:

 120 or 208/240 Vac input

 10 degree phase window

 1/8, 1/4, 1/2, or 1 second dwell time (internally switch selectable, factory set for 1/2 second) The SPM-A Synchronizer with voltage matching has a 1% voltage match as standard. See the part number chart for other options.

Theory of Operation

This section describes the general theory of operation of the two versions of the SPM-A Synchronizer. Figure 1-1 shows the SPM-A Synchronizer with voltage matching. Figure 1-2 shows a typical synchronizer system block diagram. Figure 1-3 shows a functional block diagram of the synchronizer.

Synchronizer Inputs

The SPM-A Synchronizer checks the phase angle and frequency of the bus and an off-line generator which is to be paralleled. The voltage inputs from the bus and generator are first applied to separate signal conditioner circuits. Each signal conditioner is a filter which changes the shape of the voltage input signals so they can be accurately measured. A phase offset potentiometer in the signal conditioner circuit is adjusted to compensate for phase errors. (This adjustment is factory set with identical bus and generator inputs. It should be readjusted only where a phase offset has been caused through the line transformers of the installation.) The signal conditioners also amplify the bus and generator signals and apply them to the phase detector.

Operating Modes A user-installed mode switch (single-pole, four-position) controls the relay driver.

The switch must be wired to synchronizer contacts 10 through 13 (see the plant wiring drawing). The four positions are OFF, RUN, CHECK, and PERMISSIVE.


Datasheet link


Product detail pictures:

Best MicroNet™ Plus Digital Control Suppliers - Woodward 9907-028 SPM-A speed and phase matching synchronizer – RuiMingSheng detail pictures


Related Product Guide:

The key to our success is "Good Product Quality, Reasonable Value and Efficient Service" for Best MicroNet™ Plus Digital Control Suppliers - Woodward 9907-028 SPM-A speed and phase matching synchronizer – RuiMingSheng , The product will supply to all over the world, such as: Roman, Belarus, Ethiopia, With the highest standards of product quality and service, our products have been exported to more than 25 countries like the USA, CANADA, GERMANY, FRANCE, UAE, Malaysia and so on.We are very pleased to serve customers from all over the world!
  • We have been engaged in this industry for many years, we appreciate the work attitude and production capacity of the company, this is a reputable and professional manufacturer.
    5 Stars By Raymond from Latvia - 2018.04.25 16:46
    We have been appreciated the Chinese manufacturing, this time also did not let us disappoint,good job!
    5 Stars By Victor Yanushkevich from Senegal - 2017.11.01 17:04

    Send your message to us: